en:tech:ut71
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:tech:ut71 [2022/11/27 13:29] – bullar | en:tech:ut71 [2022/11/30 11:49] (current) – [Downloads] bullar | ||
|---|---|---|---|
| Line 28: | Line 28: | ||
| I used a laser cut housing based on 2mm white acryl. The design was prepared with Inkscape. | I used a laser cut housing based on 2mm white acryl. The design was prepared with Inkscape. | ||
| Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | ||
| - | {{: | + | |
| Line 99: | Line 99: | ||
| Based on the protocol information I prepared a tiny Python program to receive the measured values, plot and store them as well as export in CSV format. This allows long-term measurements of any unit. The measurement values are stored in a SQLite database and can also be easily access with Open-Source tools like [[https:// | Based on the protocol information I prepared a tiny Python program to receive the measured values, plot and store them as well as export in CSV format. This allows long-term measurements of any unit. The measurement values are stored in a SQLite database and can also be easily access with Open-Source tools like [[https:// | ||
| + | ===== Downloads ===== | ||
| + | |||
| + | * {{: | ||
| + | * {{ : | ||
| ===== Donate ===== | ===== Donate ===== | ||
en/tech/ut71.1669555795.txt.gz · Last modified: 2022/11/27 13:29 by bullar
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
