This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tech:ut71 [2015/01/01 21:32] – [Assembly] bullar | tech:ut71 [2015/01/02 17:15] (current) – [Assembly] bullar | ||
---|---|---|---|
Line 5: | Line 5: | ||
{{: | {{: | ||
- | provides a cheap measurement solution with reasonable accuracy. The set includes an USB Interface Cable and a Windows based software. Unfortunately the USB Interface doesn' | + | provides a cheap measurement solution with reasonable accuracy. The set includes an USB Interface Cable and a Windows based software. Unfortunately the USB Interface doesn' |
^ Qty ^ Part ^ Cost ^ | ^ Qty ^ Part ^ Cost ^ | ||
Line 35: | Line 35: | ||
Cut and engrave on your laser cutter of choice. Prepare the small piece of PCB (perfboard). Glue the IR transistor (dark blue)and the IR LED. The flat part should be on the left for each. Solder the parts and the SMD resistors as shown on the picture. Last but not least connect the four wire of the PL2303HX. | Cut and engrave on your laser cutter of choice. Prepare the small piece of PCB (perfboard). Glue the IR transistor (dark blue)and the IR LED. The flat part should be on the left for each. Solder the parts and the SMD resistors as shown on the picture. Last but not least connect the four wire of the PL2303HX. | ||
- | {{ : | + | {{: |
+ | {{: | ||
==== Software ==== | ==== Software ==== | ||
{{ : | {{ : |