Translations of this page?:
TechWiki
GW60 Rollo
- GW60 Superrollo
- Hardware
- Programming
- S/W extension
- TRADFRI Modul
- Modul H/W
- Programming
- Tools
- GW60 TRADFRI adapter
- Schematic
- Programming adapter
- Housing
- Integration
Sidebar
tech:airfilter
This is an old revision of the document!
Table of Contents
Laser cutter fume extractor
Based on idea from Zach
Material
| Qty | Part | Cost |
|---|---|---|
| 1 | Foam Air Conditioner Filter  6mm thick G3 | 10,– € |
| 2 | 3M Filtrete A/C  15´´ x 24´´ (38.1cm x 61cm) #9808-12 F7/F9 | 6,–€ |
| 1 | HEPA filter HEP-5018E  \\Drawing Specification H13 | 69,95€ |
| 25kg | Activated carbon  4mm grain diameter | 120,–€ |
| 1 | Polyester Air Filter  20mm thick G4 | |
| 1 | Neoprene shelving liner  3mm thick soft | |
| 1 | Stainless mesh  6mm mesh, 1mm wire width | |
| 1 | Insect mesh  | |
| 1 | Weather stripping  |
Filter Layer
from outside to inside (inverted air flow):
- Polyster Air Filter (200 x 1445 mm)
- Stainless mesh (200 x 1445 mm)
- Insect mesh (200 x 1445 mm)
- Activated carbon (12.9 liter)
- Insect mesh (200 x 1131 mm)
- Stainless mesh (200 x 1131 mm)
- HEPA filter
- 3M Filtrete (2 layer) (200 x 880 mm)
- Stainless mesh (200 x 440 mm)
- Foam Air conditioner filter (200 x 440 mm)
tech/airfilter.1479665534.txt.gz · Last modified: 2016/11/20 18:12 by bullar
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
