This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:tech:ut71 [2022/11/27 13:30] – [Software] bullar | en:tech:ut71 [2022/11/30 11:49] (current) – [Downloads] bullar | ||
---|---|---|---|
Line 28: | Line 28: | ||
I used a laser cut housing based on 2mm white acryl. The design was prepared with Inkscape. | I used a laser cut housing based on 2mm white acryl. The design was prepared with Inkscape. | ||
Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | ||
- | {{: | + | |
Line 101: | Line 101: | ||
===== Downloads ===== | ===== Downloads ===== | ||
+ | * {{: | ||
* {{ : | * {{ : | ||
===== Donate ===== | ===== Donate ===== |