Differences

This shows you the differences between two versions of the page.

--- en:tech:jkbmscan [2024/05/18 04:50] – [Solution] bullar
+++ en:tech:jkbmscan [2024/05/18 04:52] (current) – [Software] bullar
@@ Line 64: / Line 64: @@
 The converter should be always powered (as the BMS) to avoid dead locks. Therefore I like to use VBAT as power source.
-The power supply is based on a XL7015 Buck DC to DC Converter (0.8A 150KHz 80V) from {{https://www.xlsemi.com|XLSEMI}}. The 5V output voltage can be defined by two resistors (R1/R2). The CAN interface is implemented by well-known TJA1050 from {{https://www.nxp.com/docs/en/data-sheet/TJA1050.pdf|NXP}} and a standard RJ45 plug. The heart of the converter is a 38-pin ESP32-DEVKIT.
+The power supply is based on a XL7015 Buck DC to DC Converter (0.8A 150KHz 80V) from [[https://www.xlsemi.com|XLSEMI]]. The 5V output voltage can be defined by two resistors (R1/R2). The CAN interface is implemented by well-known TJA1050 from [[https://www.nxp.com/docs/en/data-sheet/TJA1050.pdf|NXP]] and a standard RJ45 plug. The heart of the converter is a 38-pin ESP32-DEVKIT.
 <WRAP group>
@@ Line 81: / Line 81: @@
 ===== Software =====
-As mentioned the software is based on {{https://github.com/Sleeper85/esphome-jk-bms-can|ESPHome JK-BMS-CAN}}. I did only some slight modifications at the CAN protocol data.
+As mentioned the software is based on [[https://github.com/Sleeper85/esphome-jk-bms-can|ESPHome JK-BMS-CAN]]. I did only some slight modifications at the CAN protocol data.
 ++++ jk-bms-can.yaml |

TechWiki