This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tech:ut71 [2015/01/01 21:28] – [Housing] bullar | tech:ut71 [2015/01/02 17:14] – [Assembly] bullar | ||
---|---|---|---|
Line 5: | Line 5: | ||
{{: | {{: | ||
- | provides a cheap measurement solution with reasonable accuracy. The set includes an USB Interface Cable and a Windows based software. Unfortunately the USB Interface doesn' | + | provides a cheap measurement solution with reasonable accuracy. The set includes an USB Interface Cable and a Windows based software. Unfortunately the USB Interface doesn' |
^ Qty ^ Part ^ Cost ^ | ^ Qty ^ Part ^ Cost ^ | ||
Line 27: | Line 27: | ||
{{: | {{: | ||
I used a laser cut housing based on 2mm white acryl. The design was prepared with Inkscape. | I used a laser cut housing based on 2mm white acryl. The design was prepared with Inkscape. | ||
- | + | Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | |
{{: | {{: | ||
Line 33: | Line 33: | ||
==== Assembly ==== | ==== Assembly ==== | ||
- | Cut and engrave on you laser cut of choice. Prepare the small piece of PCB (perfboard) | + | Cut and engrave on your laser cutter |
- | {{ : | + | {{ : |
+ | {{: | ||
==== Software ==== | ==== Software ==== | ||
{{ : | {{ : |