This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tech:ut71 [2015/01/01 21:12] – bullar | tech:ut71 [2015/01/01 21:34] – [UT71B Interface] bullar | ||
---|---|---|---|
Line 5: | Line 5: | ||
{{: | {{: | ||
- | provides a cheap measurement solution with reasonable accuracy. The set includes an USB Interface Cable and a Windows based software. Unfortunately the USB Interface doesn' | + | provides a cheap measurement solution with reasonable accuracy. The set includes an USB Interface Cable and a Windows based software. Unfortunately the USB Interface doesn' |
^ Qty ^ Part ^ Cost ^ | ^ Qty ^ Part ^ Cost ^ | ||
Line 13: | Line 13: | ||
|1| 4k7 {{: | |1| 4k7 {{: | ||
|1| 1K0 {{: | |1| 1K0 {{: | ||
- | |1| PCB {{: | + | |1| PCB (very small piece) |
|1| Housing (3D print or laser cut) {{: | |1| Housing (3D print or laser cut) {{: | ||
Line 21: | Line 21: | ||
The USB to Serial converter PL2303HX provides 4 wires for the signals GND, +5V, RxD and TxD as shown in the schematic | The USB to Serial converter PL2303HX provides 4 wires for the signals GND, +5V, RxD and TxD as shown in the schematic | ||
- | The TxD diode is optional and not supported by the software. | + | The TxD diode is optional and not supported by the software |
==== Housing ==== | ==== Housing ==== | ||
{{: | {{: | ||
- | I used a laser cut housing based on 2mm white acryl. The design was done with Inkscape. | + | I used a laser cut housing based on 2mm white acryl. The design was prepared |
- | + | Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | |
{{: | {{: | ||
- | === Laser Cut === | + | ==== Assembly ==== |
+ | Cut and engrave on your laser cutter of choice. Prepare the small piece of PCB (perfboard). Glue the IR transistor (dark blue)and the IR LED. The flat part should be on the left for each. Solder the parts and the SMD resistors as shown on the picture. Last but not least connect the four wire of the PL2303HX. | ||
+ | {{ : | ||
==== Software ==== | ==== Software ==== | ||
{{ : | {{ : | ||
Line 42: | Line 44: | ||
The S/W has mainly the same functionality as the original one. | The S/W has mainly the same functionality as the original one. | ||
- | === Donate === | + | ^ Version ^ Remark ^ OS ^ File ^ |
+ | | V0.10 | Initial Version | Mac OS X 10.9+ | {{: | ||
+ | |||
+ | ==== Donate ==== | ||
+ | |||
+ | If you like the software feel free to donate :-) | ||
< | < |