This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tech:ut71 [2015/01/01 21:02] – bullar | tech:ut71 [2015/01/01 21:32] – [Assembly] bullar | ||
---|---|---|---|
Line 8: | Line 8: | ||
^ Qty ^ Part ^ Cost ^ | ^ Qty ^ Part ^ Cost ^ | ||
- | |1| PL2303HX or similar {{: | + | |1| PL2303HX or similar {{ : |
- | |1| IR-Fototransistor | 0.10 € | | + | |1| IR-Fototransistor |
- | |1| IR-LED | + | |1| IR-LED |
- | |1| 4k7 | 0.10 € | | + | |1| 4k7 {{: |
- | |1| 1K0 | 0.10 € | | + | |1| 1K0 {{: |
- | |1| Housing (3D print or laser cut) | 0.50 € | | + | |1| PCB (very small piece) {{: |
+ | |1| Housing (3D print or laser cut) {{: | ||
==== Schematic ==== | ==== Schematic ==== | ||
- | {{: | + | {{: |
The USB to Serial converter PL2303HX provides 4 wires for the signals GND, +5V, RxD and TxD as shown in the schematic | The USB to Serial converter PL2303HX provides 4 wires for the signals GND, +5V, RxD and TxD as shown in the schematic | ||
- | The TxD diode is optional and not supported by the software. | + | The TxD diode is optional and not supported by the software |
==== Housing ==== | ==== Housing ==== | ||
{{: | {{: | ||
- | I used a laser cut housing based on 2mm white acryl. The design was done with Inkscape. | + | I used a laser cut housing based on 2mm white acryl. The design was prepared |
- | + | Depending on the thickness of your wiring you may not need all layers. In my example I only used 4 pieces. | |
{{: | {{: | ||
- | === Laser Cut === | + | ==== Assembly ==== |
+ | Cut and engrave on your laser cutter of choice. Prepare the small piece of PCB (perfboard). Glue the IR transistor (dark blue)and the IR LED. The flat part should be on the left for each. Solder the parts and the SMD resistors as shown on the picture. Last but not least connect the four wire of the PL2303HX. | ||
+ | {{ : | ||
==== Software ==== | ==== Software ==== | ||
+ | {{ : | ||
+ | |||
The S/W is written with [[https:// | The S/W is written with [[https:// | ||
As I have just now only a license for OS X I can't provide binaries for Windows and Linux. | As I have just now only a license for OS X I can't provide binaries for Windows and Linux. | ||
Line 39: | Line 44: | ||
The S/W has mainly the same functionality as the original one. | The S/W has mainly the same functionality as the original one. | ||
- | === Donate === | + | ^ Version ^ Remark ^ OS ^ File ^ |
+ | | V0.10 | Initial Version | Mac OS X 10.9+ | {{: | ||
+ | |||
+ | ==== Donate ==== | ||
+ | |||
+ | If you like the software feel free to donate :-) | ||
< | < |