Differences

This shows you the differences between two versions of the page.

--- tech:3d_prusa [2016/02/13 17:26] – [Setup Bed] bullar
+++ tech:3d_prusa [2016/02/13 19:12] – bullar
@@ Line 1: / Line 1: @@
 ====== Prusa i3 ======
-==== Setup Bed ====
+====Wood Sheet frame====
+{{:tech:prusa_i3_frame.png?direct&300|}}
+Frame: [[http://reprap.org/wiki/Prusa_i3]] -- Laser Cut [[http://images.google.de/imgres?imgurl=https%3A%2F%2Fthingiverse-production-new.s3.amazonaws.com%2Frenders%2F5c%2F11%2F46%2Fd4%2F89%2FPrusa_i3m_-_0_preview_featured.jpg&imgrefurl=http%3A%2F%2Fwww.thingiverse.com%2Fthing%3A39889&h=472&w=628&tbnid=T-n4F9QoZr8EaM%3A&docid=pkh3aApNHE_GIM&ei=C36_Vv6qNu_b6QT924LwBg&tbm=isch&client=safari&iact=rc&uact=3&dur=713&page=1&start=0&ndsp=44&ved=0ahUKEwi-3MOIt_XKAhXvbZoKHf2tAG4QrQMISzAI|Thingiverse]]\\
+Controller (SainSmart 2-in-1): [[http://www.sainsmart.com/sainsmart-2-in-1-3d-printer-controller-board-for-reprap-arduino-betterthan-ramps.html|SainSmart 2-in-1 3D Printer Controller]] [[http://rigidtalk.com/wiki/index.php?title=SainSmart_2in1|Wiki]]
+==== Modification on Firmware ====
+Changed in ''pins.h'' in section ''#ifdef RAMPS_V_1_3'':
+<code C>
+#define ORIG_FAN_PIN       7  //#### changed for SaintSmart 2in1 orig: 9
+</code>
+Caution: The silkscreen on PCB is wrong ET0/ET1 swapped! Not changed on firmware.
+==== Setup Bed ====
 ^Item ^  X  ^  Y  ^  Z  ^  Unit  ^

TechWiki