This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
tech:3d_prusa [2016/02/13 17:25] – created bullar | tech:3d_prusa [2016/02/13 19:12] – bullar | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Prusa i3 ====== | ====== Prusa i3 ====== | ||
- | ==== Setup Bed ==== | + | ====Wood Sheet frame==== |
+ | {{: | ||
+ | |||
+ | Frame: [[http:// | ||
+ | Controller (SainSmart 2-in-1): [[http:// | ||
+ | |||
+ | ==== Modification on Firmware ==== | ||
+ | |||
+ | Changed in '' | ||
+ | <code C> | ||
+ | #define ORIG_FAN_PIN | ||
+ | </ | ||
+ | Caution: The silkscreen on PCB is wrong ET0/ET1 swapped! Not changed on firmware. | ||
+ | |||
+ | |||
+ | ==== Setup Bed ==== | ||
^Item ^ X ^ Y ^ Z ^ Unit ^ | ^Item ^ X ^ Y ^ Z ^ Unit ^ | ||
Line 9: | Line 24: | ||
|print area| 190| 190| 180| mm| | |print area| 190| 190| 180| mm| | ||
|offset bed| | |offset bed| | ||
- | |offset print area| | + | |offset print area| |
|offset extruder 2| 27| 0| 0| mm| | |offset extruder 2| 27| 0| 0| mm| |