tech:3d_prusa
Differences
This shows you the differences between two versions of the page.
| Next revisionBoth sides next revision | |||
| tech:3d_prusa [2016/02/13 17:25] – created bullar | tech:3d_prusa [2016/02/13 17:26] – [Setup Bed] bullar | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| |print area| 190| 190| 180| mm| | |print area| 190| 190| 180| mm| | ||
| |offset bed| | |offset bed| | ||
| - | |offset print area| | + | |offset print area| |
| |offset extruder 2| 27| 0| 0| mm| | |offset extruder 2| 27| 0| 0| mm| | ||
tech/3d_prusa.txt · Last modified: 2016/02/21 21:25 by bullar
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
